Thingiverse
Spool Holder
von dantyas
2
Downloads
2
Likes
0
Makes
Free Standing Spool Holder
I needed a free standing spool holder for my CR-10 rebuild as I'd done away with the control box. This build does require x8 bearings 16 x 6's 2 in each wheel, although you might be able to get away with 1, should you wish to try.
It's designed specifically for Ooznest PLA Pro filament spools at 75mm centres. But many others will also fit.
I use Ooznest as they provide recyclable cardboard spools, WE SHOULD ALL BE USING CARDBOARD SPOOLS!!!
I needed a free standing spool holder for my CR-10 rebuild as I'd done away with the control box. This build does require x8 bearings 16 x 6's 2 in each wheel, although you might be able to get away with 1, should you wish to try.
It's designed specifically for Ooznest PLA Pro filament spools at 75mm centres. But many others will also fit.
I use Ooznest as they provide recyclable cardboard spools, WE SHOULD ALL BE USING CARDBOARD SPOOLS!!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
