Thingiverse
Spool Holder
door HyjinxTuesday
0
Downloads
0
Likes
0
Makes
Another spool holder. This is a remix of
Zoltanki posted
adjustable spool holder, which is a remix also.
I liked Zoltanki design, but with the adjustable base, it wouldn't fit in the dryboxes I have built. I needed to eliminate the adjustable base, and I realized that the design would be more stable if each side was shorter.
So, I shrunk it down. I shaved off the posts that slid into the adjustable base, and I created a clip that will hold each side together.
Print 2 of each stl. 1 SpoolHolderCouple_shorter is only one side of the whole spool holder, so you'll need 2 prints of the Couple. and you'll need 2 SpoolHolderClips to anchor the sides together
Who needs another spool holder!
Zoltanki posted
adjustable spool holder, which is a remix also.
I liked Zoltanki design, but with the adjustable base, it wouldn't fit in the dryboxes I have built. I needed to eliminate the adjustable base, and I realized that the design would be more stable if each side was shorter.
So, I shrunk it down. I shaved off the posts that slid into the adjustable base, and I created a clip that will hold each side together.
Print 2 of each stl. 1 SpoolHolderCouple_shorter is only one side of the whole spool holder, so you'll need 2 prints of the Couple. and you'll need 2 SpoolHolderClips to anchor the sides together
Who needs another spool holder!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
