Thingiverse
Spool Holder with Distance Detector
von xsk8rat
3
Downloads
2
Likes
0
Makes
Accepts wide range of spool sizes. Stable while placing the spools.
Uses:
* [SparkFun Proximity Sensor Breakout - 20cm, VCNL4040 (Qwiic)](https://www.sparkfun.com/products/15177)
* [Qwiic Alphanumeric Display](https://www.sparkfun.com/products/16425)
* [SparkFun Thing Plus - ESP32 WROOM](https://www.sparkfun.com/products/15663)
* 608 skate bearings
Based on [Spool Holder Thing](https://www.thingiverse.com/thing:4716038) the other parts are there, but i will add them here. Also need to model the distance sensor.
Doesn't work well for black filament: No return signal for distance measurement.
(Kerning on this note is killing me.)
Uses:
* [SparkFun Proximity Sensor Breakout - 20cm, VCNL4040 (Qwiic)](https://www.sparkfun.com/products/15177)
* [Qwiic Alphanumeric Display](https://www.sparkfun.com/products/16425)
* [SparkFun Thing Plus - ESP32 WROOM](https://www.sparkfun.com/products/15663)
* 608 skate bearings
Based on [Spool Holder Thing](https://www.thingiverse.com/thing:4716038) the other parts are there, but i will add them here. Also need to model the distance sensor.
Doesn't work well for black filament: No return signal for distance measurement.
(Kerning on this note is killing me.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!