Thingiverse
Spool Hub
di kenwshmt
2
Download
1
Likes
0
Makes
I think you are required to design your own spool hub if you have a 3d printer, this one is mine.
It fits 8mm rod; an old mendel shaped desk inbox in my case.
Its a 10 lb roll of filament, so its a wide holed center on the plastic rings on the spool.
The machine can't pull it, you must pre slack before you print.
It fits 8mm rod; an old mendel shaped desk inbox in my case.
Its a 10 lb roll of filament, so its a wide holed center on the plastic rings on the spool.
The machine can't pull it, you must pre slack before you print.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!