Thingiverse
Spool Hub
von Guytoronto
4
Downloads
1
Likes
0
Makes
I created custom hubs to hold my spool on my Ender 3.
I printed two of these. Skateboard bearings are placed into the centre circle pocket. Then secured them to a 5/16" threaded rod with washers and nuts.
This size hub fits all my spools. Your mileage may vary.
I printed two of these. Skateboard bearings are placed into the centre circle pocket. Then secured them to a 5/16" threaded rod with washers and nuts.
This size hub fits all my spools. Your mileage may vary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!