Thingiverse
Spool Puck (work in progress)
von Kezat
4
Downloads
9
Likes
0
Makes
Universal spool holder. Using 4.5mm BB's as ball bearings.
This is a work in progress, to prevent spool tangles around the base the filament needs a little friction, still trying to come up with a good solution. A short section of tubing should work until then. (see last photo)
This is a work in progress, to prevent spool tangles around the base the filament needs a little friction, still trying to come up with a good solution. A short section of tubing should work until then. (see last photo)
Kezat veröffentlicht auch auf
15 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
