Thingiverse
Spool Spacer for FlashForge Creator 3
door ThomasWilko
5
Downloads
1
Likes
0
Makes
A ~10mm spacer that I made to raise a slightly oversized spool that was rubbing on the lower surface of the Creator 3's stock side spool holder compartment.
Can be scaled in the vertical axes in FlashPrint to make the spool sit higher or lower if so desired, although this isn't recommended.
Included is a SolidWorks part if you were wanting to modify it.
Can be scaled in the vertical axes in FlashPrint to make the spool sit higher or lower if so desired, although this isn't recommended.
Included is a SolidWorks part if you were wanting to modify it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
