Thingiverse
Spool Stop
von The1stDungeon
2
Downloads
6
Likes
0
Makes
This is for the FlashForge AD5X 4 colour printer.
The supplied spool supports aren't very good at keeping the spools on, they either run off or run into the printer frame.
I made these quickly so no doubt someone will come up with a better design
The supplied spool supports aren't very good at keeping the spools on, they either run off or run into the printer frame.
I made these quickly so no doubt someone will come up with a better design
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
