Thingiverse
Spool Tri-Holder
door SirBruter
1
Downloads
1
Likes
0
Makes
I wanted to create my own spool holder that would fit in to my room.
This holder allows hanging up to 4 spools at once (two regular or 4 slim) and print directly from the wall. The angle under which the spools are placed allows to collect the filament ends at the same place, which makes the whole setup cleaner.
Holds on to the wall with 3 screws. In the files you can find "SpoolHolder_Adapter". Print these only if you don't want to buy washers.
Dimensions:
x- 19.7cm
y- 19.2cm
z- 20.2cm
The whole print took me 23 Hours.
For the holders I used these: https://www.thingiverse.com/thing:2303349
This holder allows hanging up to 4 spools at once (two regular or 4 slim) and print directly from the wall. The angle under which the spools are placed allows to collect the filament ends at the same place, which makes the whole setup cleaner.
Holds on to the wall with 3 screws. In the files you can find "SpoolHolder_Adapter". Print these only if you don't want to buy washers.
Dimensions:
x- 19.7cm
y- 19.2cm
z- 20.2cm
The whole print took me 23 Hours.
For the holders I used these: https://www.thingiverse.com/thing:2303349
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
