Thingiverse
Spoolholder Box Accessories
von 3ff3ction
7
Downloads
4
Likes
0
Makes
These are accessories to make a nice spoolholder for your 3D printer.
1) Bracket (to hold a 40mm PVC tube; check the 'How to' for printing this one!)
2) Tube Stop
3) Tube Connector
4) Small Dust Collector
5) Big Dust Collector
6) Accessories holder (Small version; If you want to use the 'Small Dust Collector')
7) Accessories holder (Big version; If you want to use the 'Big Dust Collector')
How to print the Bracket:
Import the bracket into your printing software. Turn the bracket in the angle that matches the angle of your box walls (mostly around 5°). Next, lower the Bracket beneath the printing surface until the whole bottom is submerged. This way the bottom will be printed in the right angle... Print!
Hope you like it! Please post pictures if you made one!
1) Bracket (to hold a 40mm PVC tube; check the 'How to' for printing this one!)
2) Tube Stop
3) Tube Connector
4) Small Dust Collector
5) Big Dust Collector
6) Accessories holder (Small version; If you want to use the 'Small Dust Collector')
7) Accessories holder (Big version; If you want to use the 'Big Dust Collector')
How to print the Bracket:
Import the bracket into your printing software. Turn the bracket in the angle that matches the angle of your box walls (mostly around 5°). Next, lower the Bracket beneath the printing surface until the whole bottom is submerged. This way the bottom will be printed in the right angle... Print!
Hope you like it! Please post pictures if you made one!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!