Thingiverse
Spoon
von K4st0r
1
Downloads
1
Likes
0
Makes
Its a spoon.
It propably is able to be printed without support when standing vertically on the tip (I already flattened the tip for that pourpose but haven't tried to print it yet).
To print this you have to scale it down to 10% of the original size. Aside of that it should go quite well.
It propably is able to be printed without support when standing vertically on the tip (I already flattened the tip for that pourpose but haven't tried to print it yet).
To print this you have to scale it down to 10% of the original size. Aside of that it should go quite well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
