Thingiverse
Sport Cub Wing Bracket
di Gazorpa
19
Download
13
Likes
0
Makes
This is a wing bracket for a radio controlled model airplane.
Applies to these planes:
ParkZone Sport Cub 1.3M (discontinued)
HobbyZone Carbon Cub S+ 1.3M
**Update November 14, 2019**
I split the model lengthwise and printed the two halves in Solutech Clear PETG. After several attempts all curling off the bed, I added "ears" to the ends, which stuck it down. The posts were slightly too large in diameter, so I scraped them with a hobby knife until they fit. I'll post updated STL files and photos real soon now.
**Initial Publication**
I just finished the design, haven't printed it yet, so caveat emptor, buyer beware, etc. If anybody does print it, please upload the details and photos.
This thing will print best on edge to strengthen the posts. I'll design built-in support for the posts next.
I'm starting to print with Solutech PETG for durability. I've only done a temperature tower so far.
Applies to these planes:
ParkZone Sport Cub 1.3M (discontinued)
HobbyZone Carbon Cub S+ 1.3M
**Update November 14, 2019**
I split the model lengthwise and printed the two halves in Solutech Clear PETG. After several attempts all curling off the bed, I added "ears" to the ends, which stuck it down. The posts were slightly too large in diameter, so I scraped them with a hobby knife until they fit. I'll post updated STL files and photos real soon now.
**Initial Publication**
I just finished the design, haven't printed it yet, so caveat emptor, buyer beware, etc. If anybody does print it, please upload the details and photos.
This thing will print best on edge to strengthen the posts. I'll design built-in support for the posts next.
I'm starting to print with Solutech PETG for durability. I've only done a temperature tower so far.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
