Thingiverse
Spotmini alterations/tweaks
von NeoFuture
1
Downloads
0
Likes
0
Makes
This is some alternate parts for Spotmini.
Body increased by 6cm for more electronic space. please be aware, if using the larger body, I have adapted the covers to be slightly bigger.
The idea is to place 4 washers between the side panels and the front to allow for the standard 30mm fan (which is 10 mm thick) in order for it not to foul on the servos.
I may add additional slightly larger side chassis parts at a later date.
The base board is designed for raspberry pi 2/3/4 2 x PCA9685's (one for each side) and one MPU6050 with room for other components should you need
The fan housing is for a 30 mm fan, and has a slot to enable a 16 pin ribbon and a pi camera ribbon.
The front cover has been redesigned to house the original front cover but with an opening for the pi camera.
Body increased by 6cm for more electronic space. please be aware, if using the larger body, I have adapted the covers to be slightly bigger.
The idea is to place 4 washers between the side panels and the front to allow for the standard 30mm fan (which is 10 mm thick) in order for it not to foul on the servos.
I may add additional slightly larger side chassis parts at a later date.
The base board is designed for raspberry pi 2/3/4 2 x PCA9685's (one for each side) and one MPU6050 with room for other components should you need
The fan housing is for a 30 mm fan, and has a slot to enable a 16 pin ribbon and a pi camera ribbon.
The front cover has been redesigned to house the original front cover but with an opening for the pi camera.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
