Thingiverse
Spray can holder / trigger gun
by gldgrobler
81
Downloads
54
Likes
1
Makes
This is a remix where I seperated the trigger from the handel for flat printing to increase the durability of the trigger.
I had several triggers break in me. wasting filament and TIME!
We only live so long.
A standard 6mm bolt and nut should fit and become the pivot point for the trigger.
I have included a VERY BASIC 6mm bolt with a clip to act as a pivot, so you don't need to run to the hardware store to buy 1.
You are free to size it as you like, but I found it to be quite sturdy, and it stayed in place while using it.
I had several triggers break in me. wasting filament and TIME!
We only live so long.
A standard 6mm bolt and nut should fit and become the pivot point for the trigger.
I have included a VERY BASIC 6mm bolt with a clip to act as a pivot, so you don't need to run to the hardware store to buy 1.
You are free to size it as you like, but I found it to be quite sturdy, and it stayed in place while using it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
