Thingiverse
Household
Zum Modell
Spray can holder
734
Downloads
435
Likes
0
Makes
This spray can holder was inspired by https://www.thingiverse.com/thing:4935895
Unfortunately, that design doesn't fit American sized cans. I modeled this holder up and tested it out. I shortened it up a bit to speed up printing. It has three holes for #10 screws.
Don't mind the two color print, I was just using up some old filament on the initial print.
The openings in the rear make a good place to store your spare straws.
Unfortunately, that design doesn't fit American sized cans. I modeled this holder up and tested it out. I shortened it up a bit to speed up printing. It has three holes for #10 screws.
Don't mind the two color print, I was just using up some old filament on the initial print.
The openings in the rear make a good place to store your spare straws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
