Spring based Car

You Small spring loaded car with springs in PLA. Can be fully printed or few parts can be sourced depending the option. There is also an option to be able to dissassemble it and change the gear ratio or colors. The spring geometry has been optimised for a 0.4mm noozle. The main parts and the wheels are with standard parameters with 4 perimeter. (0,2mm layer height). The wheel axis are with 5mm brim You will need "main parts", "the wheels" and "wheel axis" in the 3mf then you have everything. Everything can be printed out of PLA except the tires that i advice being done in TPU. Pay attention the wheel for TPU tires are not the same than for O-ring tires. If you want to drift don’t put tires ;) Read the assembly procedure. https://amp.reddit.com/r/prusa3d/comments/mtndbx/just_published_my_spring_car_on_prusaprinters/ Happy printing !!! Copilot Here’s a cleaned-up version of the information: Introducing the Spring-Loaded Car Kit: Materials & Assembly: Printable Parts: Main parts, wheels, and wheel axis. Material: PLA for all components except tires (recommended TPU for tires). Tires Note: Wheel design differs between TPU tires and O-ring tires. For drifting, avoid using tires. Spring Geometry: Optimization: Designed for a 0.4mm nozzle. Layer Height: 0.2mm. Main parts & Wheels: Standard parameters with 4 perimeters. Wheel Axis: With 5mm brim. Customizability: Gear Ratio: Option to disassemble and change gear ratio. Color Options: Customizable colors. For assembly instructions, please refer to the link below: Assembly Procedure Happy printing!