Spring Christmas Tree

Tree printed full walls. Base 3walls 15%infillThe supports should be inserted about halfway up each circle and at the top near the tangency of the circle. Below are photos. The spiral is not very easy to print, you can scale the whole model to make it more stable when printing, but if you use the media as indicated, it does not give any problems.Once printed you have to screw it in, place the shaft in the hole in the base and put your thumbs on the lowest circle of the shaft (as if you were holding a mini steering wheel), now push with your thumbs in a screwing motion.The ball at the top of the tree should be glued. Position + supports: