Slicer Discord
Spring Fin Strap Retention Block – 3D-Druckmodell von Thingiverse Thingiverse

Spring Fin Strap Retention Block

von lairdb
11 Downloads
14 Likes
0 Makes
Zum Modell
Do your springs pop off your mushrooms?

(No, not a Mario reference -- I was more of a Colossal Cave type.)


After a couple of years of sadness with the original straps, I finally got springs for my side-post fins*.

(OG Jetfins forever -- but these Oceanic Accel are a lot nicer to travel with.)

So, if you're putting these on side post fins, there's a bolt to keep them from popping back off the mushroom. There's no risk of popping off when worn, but in the bag, or wrassling through the surf or up the ladder, turns out it's possible. Oops!


So, in my typical pattern of overly complex solutions for things that aren't much of a problem, I offer you not just one but two different designs for preventing pop-off.


The first is a space-filler that is locked in place by the retention bolt that's not doing it's job.


The second fills the entire bracket space, and is locked in place by the spring bolt -- theoretically the retention bolt isn't even needed, though you ca
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen