Thingiverse
springy giftbox
door Sagittarius0
5
Downloads
6
Likes
0
Makes
A gift box which, when pulled, can extend quite far. It can be a fun toy but it has thin walls, so it is not that strong.
Printsettings
Was printed ad 0.2 mm layer height.
Does need support, but the spring should be printed without support, so add a support blocker in the middle of the print (going from the bottom to the top) as shown in the figure.
Printsettings
Was printed ad 0.2 mm layer height.
Does need support, but the spring should be printed without support, so add a support blocker in the middle of the print (going from the bottom to the top) as shown in the figure.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
