Springy Piggy

Small Pig with springy body Inculdes keyring model There is an original and THICK versionTHICK is with less and thicker coils of the spring - will be more stiff but also stronger and little easier to print --- If you want to sell prints of this model - write to me Video:https://www.instagram.com/p/DMdMDeiNrTC/ More Flexi models::https://makerworld.com/en/collections/3293549-flexi --- 3D printing settings Printed with 0.2 layer height3 wallsNo infill neededNo supports needed May be harder to print than typical modelsYou will need a good bed adhesion and a good cooling You may be needed to separate spring coils from each other after a print. Usually just with your finger nails, in some more rare cases with a thin knife (scalpel)It mostly depends on your seam settings and filament stringing I'm recommending to use 'avoid crossing curled overhangs' option (like in Prusa Slicer) and a Z-hop (Lift-Z) If you will have problems with a nozzle knocking out spring parts you can use Sp