Springy Tortoise

Steppe Tortoise with Springy bodyCan be printed in parts (body + eyes), no glue neededYou can also print a keyring version (addon merged with base model)---If you will want to sell prints of this model you can ask me - I will prepare a a commercial license---Video:https://www.instagram.com/p/DIwRA-ktBG4I have more flexi models in my profile---Printing tips:Printed with 0.16mm layer height7% gyroid infill2 wallswith ADDON_Brim and ADDON_Spring-joinerMay be harder to print than typical modelsYou will need a good bed adhesion and a good coolingYou may be needed to separate spring coils from each other after a print. Usually just with your finger nails, in some more rare cases with a thin knife (scalpel)It mostly depends on your seam settings and filament stringingIt is recommended to use PrusaSlicer because of the option 'avoid crossing curled overhangs'If you will have problems with a nozzle knocking out spring parts you can use ADDON_Brim (adding a brim on sides) or even ADDON_Spring-joiner or SpringyTortoise_ADDON_Spring-joiner-Extanded wich will connect spring parts on the bottom (extanded - on the highier place too) with two lines - you will need to cut it with a knife after printADDONs should be merged with base modelFor example you can add PARTS_Body, ADDON_Brim and ADDON_Keyring, set it in the same place and merge all three models (right click menu)For installing eyes use pliersFlat part of eyes is going insideIf eyes will not fit (too big for a hole) you can use a sandpaper/file or print eyes with XY Compensation (Horizontal expansion) - try -0.05mm or even -0.1mm---