Thingiverse
Sprouting jar lid
por Ciabolo
160
Descargas
141
Likes
6
Makes
This is a lid to screw on an empty jar to make a sprouting jar. I used an empty pickles jar.
The filament I used was PETG
I designed two versions of the lid. One with bigger holes an one with smaller holes. The version with the bigger holes prints a bit better but some very small seeds may fall through the holes.
The filament I used was PETG
I designed two versions of the lid. One with bigger holes an one with smaller holes. The version with the bigger holes prints a bit better but some very small seeds may fall through the holes.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
