Sputnik 1 - OpenSource design by LeftBrain Co.

Yes take it and do with it what you well, just send pictures!!!! Feel free to look me up on my LeftBrainCo Etsy and Instagram!

https://www.etsy.com/shop/LeftBrainCo
https://www.instagram.com/leftbrainco


I did my best to make this model as accurate as possible.

Use wooden dowels for the antennas. If printed at full scale 1:1 at a height of 58CM or 22.8in the antenna would be 2.4m and 2.9m long (there are two of each length). The one I ended up printing was 1:2 scale so I could hang it in my living room without the 7+ft antenna's the full scale would have.

PARTS:

T-Busing Print as many as you feel you need. They slide into the holes on the inner structure to lock the two halves together.

Lock Tube: 2x Goes in the center opposite of of each other with the top of the T shape furthest away from each other. You can then drive a nut and bolt though both (X head facing the exhaust port). Use a long screwdriver to tighten the bolt to hold the two halves together.

T