Thingiverse
Spy Cam Case
von ScottieD369
25
Downloads
37
Likes
0
Makes
Spy Camera Case less than the size of a pack of cigarettes.
Snap fit design! SUPER TIGHT! Triangle design! MUST REMOVE ALL SUPPORT!!!
UNDER $30 !!!!!!
Some soldering required for microphone uv super glue for antennae tape everything in place. Use everything from cam kit. You only have to provide wire, glue.
Typical battery runtime is ~ 9 hours.
I also would NOT call this weather proof by any means! Sure you could get away with a splash or drizzle or snow. But water damage is a done deal.
***ALSO NOTE***
What YOU do yourself puts yourself in danger to your own risks involved. Weather it be illegal or life threatening...
Snap fit design! SUPER TIGHT! Triangle design! MUST REMOVE ALL SUPPORT!!!
UNDER $30 !!!!!!
Some soldering required for microphone uv super glue for antennae tape everything in place. Use everything from cam kit. You only have to provide wire, glue.
Typical battery runtime is ~ 9 hours.
I also would NOT call this weather proof by any means! Sure you could get away with a splash or drizzle or snow. But water damage is a done deal.
***ALSO NOTE***
What YOU do yourself puts yourself in danger to your own risks involved. Weather it be illegal or life threatening...
ScottieD369 veröffentlicht auch auf
48 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
