Thingiverse
Spyro controller stand EASY TO PRINT
door Santy777
61
Downloads
72
Likes
0
Makes
Print WITHOUT supports!
Print wings stand, without any supports, as like I show you in the photo
Only the tail need supports
link togheter all the parts with glue and filler, such as that to repair imperfection of the wall's surface
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
Print wings stand, without any supports, as like I show you in the photo
Only the tail need supports
link togheter all the parts with glue and filler, such as that to repair imperfection of the wall's surface
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
