Thingiverse
SQFMI Watchy Case
door mareklew
16
Downloads
9
Likes
0
Makes
This is a case for what's advertised as "Watchy smartwatch" and what is a rip-off from here to Alaska and back again. Anyway, I wasted $55 on that devkit that doesn't even come with basic functional firmware, and is too fragile to tinker with, so I had to make a case before I can start hacking on it.
The case is still Work-In-Progress (and might stay so), but it should fit the watchy hardware inside. There are three pieces to the case (fourth one is under development):
* CaseBottom.stl - print as is. This is the bottom of the case, the battery goes there, put a little piece of foam (or even 2x3cm cutout from a kitchen towel) over the battery to cushion it against the PCB that will come on top.
* CaseMidFrame.stl - print it on its top surface, the eInk display comes to rest on it. You will have to unplug the display from the PCB to assemble this.
* CaseTopFrame.stl is the display frame, print it laying on its top surface, you may need some supports for the corner holes. If y
The case is still Work-In-Progress (and might stay so), but it should fit the watchy hardware inside. There are three pieces to the case (fourth one is under development):
* CaseBottom.stl - print as is. This is the bottom of the case, the battery goes there, put a little piece of foam (or even 2x3cm cutout from a kitchen towel) over the battery to cushion it against the PCB that will come on top.
* CaseMidFrame.stl - print it on its top surface, the eInk display comes to rest on it. You will have to unplug the display from the PCB to assemble this.
* CaseTopFrame.stl is the display frame, print it laying on its top surface, you may need some supports for the corner holes. If y
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!