Thingiverse
Square Bonsai Pot
von Hrsnround
83
Downloads
63
Likes
0
Makes
A simple square bonsai pot with drip tray. I like my pots a little deeper than usual so they will hold big trees easier with more root growing area.
At 100% the pot measure 180x180 around the base. The top of the pot is 245x245.
The bonsai pot walls are 15 mm thick as is the bottom. The top edge of the pot has a fillet so the edges of the top are rounded. There is a 25mm drain hole directly in the middle. Running outward from the drain are 4 angled lines that will help funnel liquid to the center of the pot and out the drain hole. The overall height of the pot is 91.2 (3.5 inches). After subtracting the thickness of the bottom the bonsai planting area is 71.2 mm (3 inches) deep.
The included Drip tray is 215 mm x 215 mm at its widest point. There are 4 built in feet in the drip tray that raises the pot 5 mm off the bottom of the tray.
At 100% the pot measure 180x180 around the base. The top of the pot is 245x245.
The bonsai pot walls are 15 mm thick as is the bottom. The top edge of the pot has a fillet so the edges of the top are rounded. There is a 25mm drain hole directly in the middle. Running outward from the drain are 4 angled lines that will help funnel liquid to the center of the pot and out the drain hole. The overall height of the pot is 91.2 (3.5 inches). After subtracting the thickness of the bottom the bonsai planting area is 71.2 mm (3 inches) deep.
The included Drip tray is 215 mm x 215 mm at its widest point. There are 4 built in feet in the drip tray that raises the pot 5 mm off the bottom of the tray.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
