Thingiverse
Square Clip for Cables
por Naomiiiiiiii
10
Descargas
5
Likes
0
Makes
**__Ko-Fi:__** [https://ko-fi.com/juliettaexpress](https://ko-fi.com/juliettaexpress)
---
Remix of llegoff's [Clip cable](https://www.thingiverse.com/thing:165773). Formatted the OpenSCAD file to make it easier to read, moved limits further, and fixed measuring errors. **Don't forget to credit llegoff also when sharing!**
The following was changed:
* All measurements start from inside of clip rather than outside (so 20mm clips + 3 mm width is now 3 mm width *then* 20mm, rather than 3 mm width plus 17mm, for example)
* Corrected cable clip to have diameter actually change when set (seemed to incorrectly go off of "length" setting)
* Formatted with tabs and spaces for readibility
* Expanded customizer ranges greatly after finding the limits to be too constricting for my own use even.
Preset to 20mm square with 1 inch cable holder, perfect for RigidBot cabling!
### Changelog
**2017-09-05**
- Initial upload
---
Remix of llegoff's [Clip cable](https://www.thingiverse.com/thing:165773). Formatted the OpenSCAD file to make it easier to read, moved limits further, and fixed measuring errors. **Don't forget to credit llegoff also when sharing!**
The following was changed:
* All measurements start from inside of clip rather than outside (so 20mm clips + 3 mm width is now 3 mm width *then* 20mm, rather than 3 mm width plus 17mm, for example)
* Corrected cable clip to have diameter actually change when set (seemed to incorrectly go off of "length" setting)
* Formatted with tabs and spaces for readibility
* Expanded customizer ranges greatly after finding the limits to be too constricting for my own use even.
Preset to 20mm square with 1 inch cable holder, perfect for RigidBot cabling!
### Changelog
**2017-09-05**
- Initial upload
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!