Thingiverse
Square Drain Pipe Lid
4
Downloads
5
Likes
0
Makes
This is an end Cap and Lid Mechanism for 65mm Square Drain Pipe.
It requires either some m3 threaded rod or m3 screws with an length of 40mm.
It also requires a small Torsion Spring bent as per the photo. The spring must allow the m3 rod/screw to fit inside.
It requires either some m3 threaded rod or m3 screws with an length of 40mm.
It also requires a small Torsion Spring bent as per the photo. The spring must allow the m3 rod/screw to fit inside.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
