Squared Minnow Lure

This is a VERY simple lure to make. Nothing special about it at all. The point of this lure is to have a lure that's easy to make, and and easy to print.
I also wanted a lure to use for testing twisted wire, and through wire strength later on.

Volume is 11.7g/cm3 and length is about 3.5 inches long (about 90MM)
Pause at layer 38 to add your steel bb in for weight.
Print setting of 4 walls, 5% infill will get the lure to about 8.47g
weight out your hardware first and add that to 8.47g and see if it will go over/under the volume of 11.7g.
Over that will theoretically make the lure sink, and under that will float.

Happy printing !


https://youtube.com/shorts/2uKmPoJInDk?feature=share