Thingiverse
Squircle planter vase mode
von madella__
3
Downloads
0
Likes
0
Makes
A cute small planter that can covers squared pots.
I decided to try different numbers of fins, since the shape still looks quite balanced even with fewer of them. the width of each fin is (75/n_of_fins)*2 mm.
The printed version has 100 fins.
With fewer than 40, it looks ugly to me.
Squircle design of the base in the last photo.
I printed with 0.6 mm nozzle, in spiral mode.
The whole print took 3.5 hours.
PLA GEEETECH Marble:
https://s.click.aliexpress.com/e/_c3uXzGGf
Link of pots that I used:
https://s.click.aliexpress.com/e/_c3lIvwcB
Even though I’m used to slicing with Cura, I got better results with this planter in PrusaSlicer.
On request I can give also the 3df.
I decided to try different numbers of fins, since the shape still looks quite balanced even with fewer of them. the width of each fin is (75/n_of_fins)*2 mm.
The printed version has 100 fins.
With fewer than 40, it looks ugly to me.
Squircle design of the base in the last photo.
I printed with 0.6 mm nozzle, in spiral mode.
The whole print took 3.5 hours.
PLA GEEETECH Marble:
https://s.click.aliexpress.com/e/_c3uXzGGf
Link of pots that I used:
https://s.click.aliexpress.com/e/_c3lIvwcB
Even though I’m used to slicing with Cura, I got better results with this planter in PrusaSlicer.
On request I can give also the 3df.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
