Slicer Discord
sr-71 glider – 3D-Druckmodell von Thingiverse Thingiverse

sr-71 glider

von sparhu
8 Downloads
13 Likes
0 Makes
Zum Modell
I designed this bird to glide, it's small so make sure you have a good eye. Have tested it some inside my house, and it seem's to be good for the task, however it's fast and my house only has so much room before it hits the wall. Haven't done extensive testing on it yet, but I'll upload this anyways just in case anyone wants it. It'll definitely need up elevation trimmed into it.

UPDATE: I just tested it outdoors, it flies pretty much like you'd expect an sr-71 to fly, you can hand launch it, but make sure you throw it fast. Honestly a rubber band on a stick is the best method. It required a little bit of trimming (up elevation, with one side a bit more up than the other to counteract a slight tendency to roll) It's FAST, and once you've got it trimmed it will easily fly at least 100' from you if not much more. Make sure you have a nice big field to launch it in, mine got stuck in a tree. Printing another as I type this. Was hesitant to think this would fly as well as it does, be ca
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen