Thingiverse
Sram spectro S7
von Kaktus0419
2
Downloads
3
Likes
0
Makes
This is Sram Spectro S7 enclosure.
Printed on sapphire pro, for my friend. Should fit with a little snap. Feel free to edit, I used Petg, but ASA, ABS should work fine, if not fit, try horizontal expansion. Remember to rotate 180 degrees like on photo.
Printed on sapphire pro, for my friend. Should fit with a little snap. Feel free to edit, I used Petg, but ASA, ABS should work fine, if not fit, try horizontal expansion. Remember to rotate 180 degrees like on photo.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
