SSD mount for PCIE risers

I designed this to allow installing extra video cards inside a Thermaltake V150 microatx case but it will work with other cases. This mount screws onto standard 2.5" sata mount spots and has screw holes to mount a GPU riser card. This is best suited to RTX 3060ti's or smaller cards, i could not fit a RTX 3070 on this mount as it was too tall for my setup. Two different versions of the mount are included, one is for a single PCIE GPU riser, and the other allows two PCIE GPU Risers.

What you will need:
You will need to source M3x7mm screws for the PCIE riser
You will need to re-use the screws and rubber feet (optional) supplied with the case.
You will need to print out your mount of choice

Printing:
I printed using PLA
I printed flat side down with no supports, no raft, and no brim/wall.
I used an infill of 15%

Usage:
To make installation easier, use one of the HDD screws and pre-screw it half0way into the mounting holes. It helps pre-thread them and makes install easier