Thingiverse
stable usb microscope stand
por octo
1.3k
Descargas
1.1k
Likes
46
Makes
##### Just like many others i found the cheapo USB orginal microscope stand useless.
However I didn't want to go out and buy rods and such, I wanted to make a cheaper design.
I used rack and pinion design to regulate height.
Now I can control the microscope height smoothly and without wobbling. Tighten the axel nuts and bolts to your liking.
Needed:
* 3 M3 nuts and bolts about 12-15mm length to tighten the axel so it doesn't slide on its own and to keep the microscope fastend.
* The holes are 3.4 mm which is about 1/8 inch (in case you have no love for the metric system).
Print:
* With supports on.
* 0,15 layer height.
* See image for recommended print orientation.
* If you find that movement is not soft try to print the pinion with a smaller layer height or otherwise with higher surface quality.
However I didn't want to go out and buy rods and such, I wanted to make a cheaper design.
I used rack and pinion design to regulate height.
Now I can control the microscope height smoothly and without wobbling. Tighten the axel nuts and bolts to your liking.
Needed:
* 3 M3 nuts and bolts about 12-15mm length to tighten the axel so it doesn't slide on its own and to keep the microscope fastend.
* The holes are 3.4 mm which is about 1/8 inch (in case you have no love for the metric system).
Print:
* With supports on.
* 0,15 layer height.
* See image for recommended print orientation.
* If you find that movement is not soft try to print the pinion with a smaller layer height or otherwise with higher surface quality.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
