Thingiverse

Stable Watch Stand

by Smackis

3.8k Downloads

3.4k Likes

23 Makes

Go to Model

I made a non adjustable version of the adjustable watch stand. Instead of the adjustability I made multiple version of the stand to fit wrist sizes between 140 mm and 210 mm in 5 mm increments. This solution is much more stable and easier to print (for obvious reasons) than the adjustable version.

I also made some changes to the base and changed the connection between the base and the stand. Base is now slightly lower profile and the stand has two "feet" that are a friction fit into the base. This means that the stand not attaches more firmly to the base so watches don´t fall so easily. I am sure friction fit will be slightly different on different printers and materials so I made it so that it is easy to adjust the stand with a few licks from a sandpaper should it be too tight. If fit is too loose there is an alternative set of bases included named *Tight that are 0.4 mm tighter than standard version.

clock cool desk display stand easy print holder organization rolex stable supportless useful watch watchstand clock cool desk display stand easy print holder organization rolex stable supportless useful watch watchstand clock cool desk display stand easy print holder organization rolex stable supportless useful watch watchstand

Source

Thingiverse

What you need to print this: Beginner Low confidence

Why?

no supports

Support-free Single piece

Supports 0/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer