Stack-able moss pole

1st generation stack-able moss pole,

Features:
1. enclosed at 3 sides to minimise evaporation.
2. ensure roots are contained within the pole.
3. Print with transparent PETG for the "back" to monitor root development.
4. Fix in M4 brass insert and insert the "back" only. Use 10mm M4 screws when securing the connector and base to the body of the moss pole.
5. "Front" can be snapped on to allow easy removal and replacement. Also allows easy additions of moss or your preferred potting material.
6. Fix brass insert into the holes of the tanks. Screw in a m4 screw into the bottom hole of the tank to control the water dripping rate.

Print setting:
1. "Tank" requires support.
2. Lay the "front" on the print bed to minimize the need to support.
3. Lay the "back" on its print bed if your printer is not stable enough for a 200mm tall print object.
4. Print with PETG, 220C. Print bed at 80C.

Steps to use.
1. Drill a hole at the bottom of the pot.
2. Fill a section of the moss pole and connect i