MakerWorld
Other Hobby & DIY
Model downloaden
Stackable Ammo Tray V2 (various calibers)
202
Downloads
51
Likes
85
Makes
This is a stackable ammo tray design to fit into a common ammo can (trays are 3.8 in wide). It is available in the following calibers:9mm Luger, 100 rounds45 ACP, 100 rounds40 S&W, 100 rounds38 Special, 100 rounds380 ACP, 100 rounds.357 Magnum, 100 rounds.44 Magnum, 50 rounds.22 Long Rifle, 200 rounds10mm Auto, 100 roundsPrinting InstructionsPLA works, but I would suggest PETG for longevity, especially if you are transporting then. PLA will soften and warp in a hot car, absorb moisture and become brittle over time, degrade in sunlight, and wont resist oils/solvents. PETG should address most of these concerns, and provide good life. Print with random seams and scarf joints for a combination of strength and aesthetics, but longer print time. Contact area on the bottom is small, so be sure the bed is clean, but don't use a brim unless you like pain. ConfigurationThe design is also configurable for another type of ammo, another size of box, or another preferred number of rounds.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!