Slicer Discord
Stackable Coke bottle windmill (VAWT) for bottle dynamo – 3D-Druckmodell von Thingiverse Thingiverse
Stackable Coke bottle windmill (VAWT) for bottle dynamo – Bild 1 Stackable Coke bottle windmill (VAWT) for bottle dynamo – Bild 2
Learning

Stackable Coke bottle windmill (VAWT) for bottle dynamo

von Ktronik · Learning
47 Downloads
29 Likes
0 Makes
Zum Modell
Real Quick and simple to make, VAWT for charging of AA batterys and USB stuff.

Print out STL and recycle or drink 6 / 2lt coke bottles, cut each in half leaving the screw neck intact. Load into coke bottles into holder and press fit onto a 6V 3W bottle dynamo, this one is made to fit a bottle dynamo I allready had.

stack them on top of each other to get the power needed, for a given wind speed.

With load matching circuits we could boost the output to around 5w.

could also make big stack, and finish with another bottle dynamo on the other end, I will make a endstop version of the block so you can have big stacks and 2 bottle dynamos. ~ 10w boosted

you could probley go down to your local bike shop, and get find a few that they have not tossed out. I did and got a crate full!! for the sake of some plastic, your 3D printer, and a few recycled bottles you can charge you AA batterys and USB stuff with the circuits I have. Electronics would be less than $5 to buy parts for a
Kategorie
Learning
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, TPU
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen