Thingiverse
Stackable epoxi cup with spatula
von Dvogonen
410
Downloads
649
Likes
1
Makes
I often use epoxy to fuse 3D-printed parts. Usually this means that I need a very small batch at a time. Each application uses up a cup and a spatula. Finding suitable mixing cups that do not tip over or are too large has been a problem. Getting hold of suitable spatulas is easier. I often use disposable chopsticks. But that requires cutting the tip to form the small flat point that is needed. Another problem is that I hate cleaning up epoxy spill caused by the spatula falling onto the table. I need somewhere safe to place the spatula after application.
The solution for me has been this design of a small, stackable cup with a small spatula attached. There is an extra area available where the spatula can be placed after use.
I print a batch of these at a time and store them together with the epoxy. This way I always have a cup available when I need one.
The FreeCAD model file is included. Use it for whatever you want.
The solution for me has been this design of a small, stackable cup with a small spatula attached. There is an extra area available where the spatula can be placed after use.
I print a batch of these at a time and store them together with the epoxy. This way I always have a cup available when I need one.
The FreeCAD model file is included. Use it for whatever you want.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!