MakerWorld
3D Printer Accessories
Model downloaden
Stackable Filament Dry Box Lid with PC4 Cap
168
Downloads
55
Likes
121
Makes
This lid replaces the original lid on the PRAKI cereal box container allowing you to feed filament thru a PC4 fitting. Seal container without cutting into it. Use knurled cap to seal container when not in use. Manual tree supports required. Do not disable supports. This version of the model requires supports in three key areas:Under the thread as it is sunken further into the cap to allow the lid to be stackable with other containers.Around the thread as the opening is wide enough to allow your fingers to tighten/loosen the cap.Under the hinges.Use smooth PEI plate for best cosmetic result since the lid is printed face down. Check out the alternate version here Filament Dry Box Lid with PC4 Cap. This alternative version requires less support material, but isn't stackable.
LTNine publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
