Thingiverse
Tools
Zum Modell
Stackable, Labeled Organizer Bin - Gridfinity Compatible - No Supports!
86
Downloads
186
Likes
1
Makes
Fully stackable Gridfinity compatible bins. No supports required for printing. Designed for our grid setup to sort hardware at work.
They have an angled face for labels to be applied, and the heights are adjusted slightly so when stacked they are all the same height. There is a cutout in the back for increased visibility of the label for the bin behind.
Designed for 12mm wide labels, 35mm and 70mm lengths work well if your label maker can be programmed for that.
*** UPDATE 3.18.2026 ***
Added configurations for 2x2 and 3x1 bins. These versions are still stackable and require no support.
They have an angled face for labels to be applied, and the heights are adjusted slightly so when stacked they are all the same height. There is a cutout in the back for increased visibility of the label for the bin behind.
Designed for 12mm wide labels, 35mm and 70mm lengths work well if your label maker can be programmed for that.
*** UPDATE 3.18.2026 ***
Added configurations for 2x2 and 3x1 bins. These versions are still stackable and require no support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
