Stackable wall-mounted Magazine Holder / Hanger

Wall holder for magazines and paper sheets. The holders are stackable, so you can start with 1 and add more. There are two front designs provided: Flat and patterned (pyramid pattern).

One holder fits about 3 pcs of 21 cm wide, 3 mm thick magazines. The holder inside is (WxHxD) 22.5x20x1.6 cm. Note that the magazine will extend above the height ;).

In each holder pair, the hooks are placed on the lower holder to avoid edges of papers jamming against them.


**Print Instructions**
Before you print anything else, you might want to print the bottom of a holder to see that the rip-off tabs work correctly. You can see in an image what they look like in Prusaslicer.

Print 1 one of the Front holders to go in the front and the print the regular "Holder" for the others. Print 2 wall mounts. Orient as in the attached build plate image. (I have to figure out how to orient them in the Fusion 360 STL export..)

The pads around the edges of the holders are to keep them down on the bu