Stackable Water Bottle Dryer with spout

⬇⬇⬇⬇Pls read this⬇⬇⬇⬇ Hi:) I am new on Makerworld. The last few models I have made is just getting familiar to the website. This is the first model that I have spent days making and put a lot of effort into. I would really appreciate if you can download this model. In this, I made it the right diameter so it would save some filament and also be able to dry standard water bottles. I made a opening with angle so the extra water can drip into your sink or a other water collection thing. Here are the settings I tested with0.2 layer hightTree supports(Maybe you can print without supports. I wanted to be safe. Supports was removed with a cutter.)Brims(Because my printer has BAD bed adhesion)0.4 wall thickness0.6 top and bottom thickness10% infillCubic infill180mm/sec speed Here are the slicer settings I recommend:0.2mm layer hightTree supports(might be hard to remove)Brim (only if you have poor bed adhesion)0.6 wall thickness0.6 top and bottom thickness10%-40% infill (depending on your water