Thingiverse
Stackable XYZ 20mm Calibration Cube
von Mr_Helpmann
104
Downloads
68
Likes
2
Makes
This is a 20x20x20mm Calibration Cube:
I printed many cubes to test changes of my printers, slicer settings or new filaments.
I have accumulated a lot of cubes over time.
When getting rid of my old cubes I thought it would be nice to build something with them.
Therefore I made this cube pluggable.
With the ability to put the test-cubes on top of each other, you can now store the cubes efficiently or build something fun.
I am curious which monuments will rise from my test prints over time.
I printed many cubes to test changes of my printers, slicer settings or new filaments.
I have accumulated a lot of cubes over time.
When getting rid of my old cubes I thought it would be nice to build something with them.
Therefore I made this cube pluggable.
With the ability to put the test-cubes on top of each other, you can now store the cubes efficiently or build something fun.
I am curious which monuments will rise from my test prints over time.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
