Thingiverse
Stacked Clean Up Sluice
von Trippsy25
156
Downloads
111
Likes
1
Makes
Work in progress. Upon uploading Ive seen a couple of things I need to adjust. Nothing that makes it unworkable but minor cosmetic changes.
Stackable cleanup sluice.
About 150mm wide and 200mm long, withbeach section about 45mm high. The slope is 5 degrees. And the inlet is 15mm (internal diameter).
Print one top section and multiple bottom sections (as many as you like) and stack them up, rotating each section 180 degrees as you go down.
More info later.
Enjoy!
Stackable cleanup sluice.
About 150mm wide and 200mm long, withbeach section about 45mm high. The slope is 5 degrees. And the inlet is 15mm (internal diameter).
Print one top section and multiple bottom sections (as many as you like) and stack them up, rotating each section 180 degrees as you go down.
More info later.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!