Stacking box optimized for 0,4 nozzle

26.02.2019
I added a lid. It fits the box quite tightly (as I needed ;))
If the fit is too tight, you can scale the lid in the silcer a few percent in the x and y axes.



I really like the design of the Stacking box ( https://www.thingiverse.com/thing:691127 ), but it is optimized for a large diameter nozzle, and with 0,4mm nozzle does not go well.

So I created this project for a 0.4 nozzle and layer width 0,5 mm.


It is a relatively fast print, the box prints about 3 hours (60 mm/s printing speed).