Stages SB20 Bottle Relocation Bracket

This is a bracket to relocate the water bottle holders for a Stages SB20 smart bike. It moves the bottles a few inches forward and up so you don't have to bend quite as far to reach them, great if you set the bike up in a more upright position.I printed on the rear edge as shown in the screenshot, with a brim and custom supports under the larger screw boss and interior boss channel. I used 100% infill to make sure it was strong enough, but it might be fine with less.The factory screws are used to mount the bracket to the frame, and then I used M4-0.70 screws to mount the bottle holders to the bracket. Screw lengths were M4x6mm for the lower hole closer to rider, M4x10mm (with 3 M4 washers to prevent screw from digging into bike frame) for the upper hole toward the front of the bike. I was able to tap the plastic holes for M4-0.70 successfullyPrint SettingsPrinter Brand:CrealityPrinter: Ender-3 v2Rafts:NoSupports: YesResolution:0.2Infill: 100%Filament: Hatchbox PLABlack Notes: Ender