Thingiverse
StageTop Frame Lock Spanner
door SpacelessLin
100
Downloads
60
Likes
0
Makes
Made for StageTop
Applying the frame locks really annoys me a lot, so I made this. I printed it with 0.4mm nozzle, 8 walls, 50% infill, no support. Note these parameters are too overkill for this little tool....
Based on the finetuning situation of your printer, you might need to scale up the model slightly, perhaps by 1% to 3%.
Should be able to print without support with most printer. There are some rounded edges at the bottom.
Applying the frame locks really annoys me a lot, so I made this. I printed it with 0.4mm nozzle, 8 walls, 50% infill, no support. Note these parameters are too overkill for this little tool....
Based on the finetuning situation of your printer, you might need to scale up the model slightly, perhaps by 1% to 3%.
Should be able to print without support with most printer. There are some rounded edges at the bottom.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!