Thingiverse
Staired Planter
von TheoIII
47
Downloads
34
Likes
0
Makes
This was a project for myself to accomplish and practice within Fusion 360.
The design is sized at 150x150mm's which I believe should be able to be printed on a majority of printers.
At this time I have not printed this design as my printer is down due to age, wear and tear. I do not expect any issues with printing this design due to its simplicity. If you decided to print this please feel free to share any input on the design and issues you may run into.
I suggest the use of infill for this design of approximately 15%. This is to support the bottom thickness of 5mm and also the staircases while bridging.
Thanks for looking at my project.
The design is sized at 150x150mm's which I believe should be able to be printed on a majority of printers.
At this time I have not printed this design as my printer is down due to age, wear and tear. I do not expect any issues with printing this design due to its simplicity. If you decided to print this please feel free to share any input on the design and issues you may run into.
I suggest the use of infill for this design of approximately 15%. This is to support the bottom thickness of 5mm and also the staircases while bridging.
Thanks for looking at my project.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!